Category: Main page » Electronics for home living

Hand Clap Electronic Control

We have all seen the commercial on TV .......... CLAP - ON - CLAP - OFF - THE - CLAPPER ............ well here is a circuit that will perform that same function.

Circuit operation is as follows. A single hand clap will be picked up by the electric mic which is coupled through C1 into the op amp IC1. The output of IC1 triggers the 555 IC timer IC2 which is configured as a monostable multivibrater. The trigger pulse is stretched by IC2 and outputs a pulse to IC3 a D type flip flop. Because of the three state counter arrangement of IC3, two sharp claps are required before IC3 will output a high to Q1 which will turn on K1 relay and any device connected to K1's switch contacts. Two more claps will clock IC3 again and will turn off Q1 and any device connected to the K1's contacts. I had my unit connected to my xmas tree lights so that I wouldn't have to crawl behind the tree to turn the lights on and off. Sensitivity for the circuit is R3 and should be adjusted so that the circuit ignores normal room noise.

Hand Clap Electronic Control



Source:www.home.maine.rr.com

Revestroke 2010-12-05 10:06:15
I am new to electronics and not able to connect the 100,000 ohm trimmer potential(R3) in the clap switch. please help.

[Reply] [Reply with quote]
↑ +6 ↓
neel 2010-10-13 21:27:56
i make clap switch n my lighting must on

[Reply] [Reply with quote]
↑ +14 ↓
kishan 2010-09-13 16:19:39
i need to make clap switch. and your circuit through done my work thank you very much.

[Reply] [Reply with quote]
↑ +16 ↓

Pages: [1]

Leave a comment

Your name:
Your Email:

Comment:
Type the characters: *
captcha
Refresh